9/18/2023 0 Comments Flashing lights model![]() Power Interruption: Power was lost for several AC line voltage cycles and EasyStart shut down to prevent an overload.Power Interruption or Short Cycle Timer Active (FRM B26 and earlier) Short-Cycle Timer Active (FRM B27 or later) ![]() See the EasyStart Bluetooth Diagnostics Manual (X36, X48 and X72 models only) for more information.ĮasyStart is operating as expected without any active faults Note: Observing the physical LEDs may still be best for real time troubleshooting, however Bluetooth users (-BLUE models) can see this information from the App. ![]() Some faults with the potential to cause damage are not self-reset and require removing power. Self-Resetting faults will reset automatically and attempt a restart after three minutes. Continuous 1 second flashing indicates a single flash. There will be 1/2 second between flashes in a sequence and 1 second between repeating sequences. If EasyStart detects a problem, it will flash a red LED to indicate a problem. A short time later the compressor should start. These are LEDs on the EasyStart circuit board that greatly speed up any troubleshooting, including during installation.Ī green power LED will light when power is applied to EasyStart. ![]() However, it is always checking to make sure the system is functioning normally to prevent damage and will indicate what it sees through its indicator lights. All other models using three LED indications should see EasyStart Solid Indicator Lights for diagnostic information.ĮasyStart is a device that once installed is a "set it and forget it" kind of device. This document explains fault indication on -BLUE and -UL models. EasyStart LED Indicator Lights - Flashing Lights ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |